Below are the typical workscopes for Process Engineering Internship Student, but not limited to:
- Process Simulation Support: Assist in developing or updating process models using tools like Aspen HYSYS, Aspen Plus, or PRO/II.
- PFD & P&ID Drafting/Review: Support in preparing or checking Process Flow Diagrams (PFDs) and Piping & Instrumentation Diagrams (P&IDs) under supervision.
- Line & Equipment Sizing : Perform preliminary calculations for line sizing, pump sizing, or vessel dimensioning based on given process conditions.
- Mass and Energy Balance Development : Help create or update material and energy balances for specific systems or units.
- Data Compilation and Technical Documentation: Organize equipment datasheets, design basis documents, or vendor technical information.
- Safety and Relief System Checks: Support in performing or reviewing PSV sizing, HAZOP actions, or flare load summary updates.
- Process Datasheet Preparation: Assist in preparing or updating process datasheets for equipment like heat exchangers, pumps, or columns.
- Benchmarking and Literature Search: Research design standards, past project documents, or technology references for concept selection or design validation.
- Process Optimization Studies: Contribute to small-scale optimization studies (e.g., energy savings, bottlenecking analysis) under guidance.
- Technical Presentation or Reporting: Prepare presentation slides or technical reports to summarize findings or support internal design reviews.
